This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Garmin 965 not Charging until 100%

Hello,

My Garmin 965 watch is not going properly until 100% charge, it stops around 88%-93%; any idea how I could fix this please ?

Top Replies

Nazebrock 6 months ago in reply to Johnthecyclist +1

Not really a fix but i was requested by Garmin to send back my watch to get a new one.
Garmin-Sierra 6 months ago +1
All,

Thank you for sharing. I would like to make sure everyone experiencing this is added to an internal investigation. Please respond to the following.
1. If you allow your battery to drain to 0%, plug…
flocsy🤠 6 months ago in reply to Garmin-Sierra +1

Garmin-Sierra can you tell us how long it should take according to Garmin to charge fr965 from 0% to 100%? I'm asking this because it takes much longer than my sons' fr245 and fr55 or my old fenix6.…

All Replies

0 flocsy🤠 10 months ago

How long do you wait before disconnecting? At ~90% it slows down a bit

0 Nazebrock 6 months ago

Hi,

Exact same issue here. I'm addressing my second ticket to Garmin.

It sometimes stucks or even decreasing from 90% around to 80% around.

0 LazyT 6 months ago in reply to Nazebrock

Same here.

0 Whatever 6 months ago in reply to LazyT

Same :/

0 Guitamarda 6 months ago

A mí me pasa igual, se queda en el 96% por ejemplo y al desconectarlo del cable se baja al 87%

0 Johnthecyclist 6 months ago

Same here the charging is all over the place, at one point it was showing it had charged to 95%, left it a bit longer and it was then showing 89%. Restarted the watch and it's now showing 90%. Not good for such an expensive watch. Any fix?

0 Nazebrock 6 months ago in reply to Johnthecyclist

Not really a fix but i was requested by Garmin to send back my watch to get a new one.

0 LazyT 6 months ago in reply to Nazebrock

I don't think the accu is broken, looks like a generell problem.

Garmin-Sierra

Could you look at this?

Thanks!

0 oBuTTuSo 6 months ago in reply to LazyT

I'm guessing it's a calibration issue of the gauge.

A couple of times I've used an USB current meter while charging, and can see that the watch continues to charge for quite some time after displaying 100%...

0 Nazebrock 6 months ago in reply to LazyT

At that time I fully agree with you but still... It's boring to achieve getting a 100% charged watch. One of my friend bought his 965 few weeks ago. He doesn't have any issue so far.