This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HRM problems after update

So my 955 Solar updated automatically today to the newest update (22.24), and after that, the built-in HR monitor immediately stopped working. I noticed this later when going for a run, and I tried the trick mentioned here by re-installing the update. This worked to the extent that the HR monitor now turns on, but when I went for a run, I noticed that my displayed HR was about 30 bpm lower than usual, so clearly, something is not right with the new software. Hope this can be fixed promptly!

Top Replies

Birnikos 8 months ago +1

As i noticed the same issue i went straight to the sensors settings in my watch, and what i discovered it was that bluetooth HRM sensor had been unpaired due to the new firmware that introduce the encryption…

All Replies

0 5578887 8 months ago

Welcome aboard the boat of people with HRM problems after updates! Enjoy the ride!

0 Birnikos 8 months ago

As i noticed the same issue i went straight to the sensors settings in my watch, and what i discovered it was that bluetooth HRM sensor had been unpaired due to the new firmware that introduce the encryption protocol. I had to pair it again, but now uses the ANT+.