This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Fw 12.27 runpod not showing up in overview after run and runpower differs from earlier similar runs.

Did a 60 minute run on treadmill today. I used my runpod instead of HRM-Pro. Now when I look at the "after exercise report" the pod is not listed under equipment. I have the dynamics from it, and they seem normal, but the runpower is way lower compared to earlier runs at the same pace with the pod.

Watch was updated with 12.27 yesterday.

I did a similar run tuesday with the same setup except watch had fw 12.23 and that time the runpower seemed accurate.

Anyone else experiencing the same?

I will use my HRM-pro next time to see if it I get a difference between similar runs.

0 Christian over 3 years ago

I have never seen my running pod listed after a run(under any firmware).

The only thing I have ever seen is my HRM Pro.

0 MariusGF over 3 years ago

Mine is hit and miss; more miss; out of 10 runs I have it in 3. Under the 11.12 I didn't have it at all. The power seems to be the same regardless of the detection on Garmin connect.