This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wotkout without a map

I created a pace-based running workout in Connect, sent it to a watch and run. After sincing back I couldn't see a map for that workout. However, there was a gps signal and it controlled my pace during the run and I have pace data in Connect. All my predefined run workouts are without maps

For free runs (without predefined workouts in Connect) maps are OK

For my heartrate based bike workouts maps are OK

The only difference I could see is that workouts with a map are preceded by the location name (automatically). The workouts without a map are named as I named them in Connect

What should I do to correct that and get a maps for my run workouts?

0 e7andy 10 months ago

Can you post a link to one of the activities that hasn't got a map?

0 3141810 10 months ago in reply to e7andy

This one without a map. However, pace and altitude are OK

https://connect.garmin.com/modern/activity/11239737837

This one with a map, same location

connect.garmin.com/.../11133115584

0 e7andy 10 months ago in reply to 3141810

3141810 said:
However, pace and altitude are OK

The watch can calculate the pace and will measure the altitude without the GPS.

Do you make sure you get the green GPS before you press start?

0 3141810 10 months ago in reply to e7andy

The problem is that all predefined running wokouts are without maps. And free runs are with maps. Sometimes free runs show the track not from the beginning but alwyas have some data on the map.

0 e7andy 10 months ago in reply to 3141810

3141810 said:
Sometimes free runs show the track not from the beginning

It sounds like you don't wait until you get the green GPS (the red bar at the top of the watch should switch to green). Try that with a workout run and see if that helps.