This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No grouping of steps of a configured training session - firmware 9.60

Hi,

After updating the watch from version 9.00 to 9.60. On Garmin Connect, after sync the previously configured training, I can't see the stages.

The first screen shows the old version, the second the new one.

Any ideas and a solution to this problem?

Greetings
Radek

0 linsguilherme over 3 years ago

It is related to the auto-detection of run/walk/idle times.
I checked if the workout has only active intervals the grouping works as on older versions.
I tried to figure out how to fix it, but I think Garmin needs to change some code here.