Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Following a recorded pool swim, the watch ceases to count floors until it resets at midnight

hermarga
over 3 years ago

Since the latest software update, if I record a pool swim, I have no floor count afterwards. Following the midnight reset, it works fine the next day if there is no pool swim. Any thoughts?

  • 0 over 3 years ago

    Report the bug via the form with the beta would be my thought. 

  • 0 over 3 years ago

    Perhaps the hole in the barometric altimeter is dirty and when it gets wet it does not detect the pressure change.

  • Former Member
    0 Former Member over 3 years ago
    hermarga said:
    Following the midnight reset, it works fine the next day if there is no pool swim. Any thoughts?

    Garmin has turned off the temperature/barometer sensor for pool swimming.  A Garmin rep has stated it was due to excessive corrosion with chlorine.  Anyway, you need the barometer to count floors and for some reason the temperature/barometer sensor is not turning back on after completing a pool swim activity until the following day.  It's a bug and should be reported. 

  • 0 over 3 years ago in reply to Former Member

    Check out Beta 8.02 notes:

    • Fix an issue that could temporarily prevent temperature and altitude readings after a pool swim activity.

    I would suspect this state would impact floor counts.