This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

945 and sensors probs after 5.0 sw upfate

Luca_Agostino over 5 years ago

someone knows after update to 5.0 all sensors doesn't work anymore?????

0 Fredrik_Coulter over 5 years ago

Try rebooting your watch.

0 Luca_Agostino over 5 years ago in reply to Fredrik_Coulter

already do but doesn't work

0 Former Member over 5 years ago in reply to Luca_Agostino

Just updated and checked my two HR straps, WHR, pulse ox, cadence, speed, Tempe and Stryd sensors. All are working properly.

0 101101 over 5 years ago in reply to Former Member

Since updating to 5.00 I’ve also successfully used my Polar H10 (hrm), Wahoo cadence, bike power meter, Tempe, Stryd, and Humon Hex.

OP, what sensors are you referring to? Internal or ANT/BT?

0 Dr Phil over 5 years ago

Check in the About page on the watch and see what versions you have.

0 jmto over 5 years ago

This just in on the release thread: https://forums.garmin.com/sports-fitness/running-multisport/f/forerunner-945/235809/phased-rollout-20---forerunner-945-sw-5-00/1122015#1122015

So check the sensor settings, they might have been set to "Off". So "Sensors & Accessories" => Your sensor => "Status", if it's "Off", change it.