Today I was riding my trainer and noticed a strange behavior. Showing the power gauge screen (top arc shows power zone with arrow pointing to current zone) when I went into zone 7 the arrow would disappear and the zone color band did not get bold. If I backed off power slightly to zone 6, that would display fine, it was only with zone 7 that I had an issue.
I'm on firmware 4.10
Further update. Today I decided to try using the graphical power gauge on a custom data field screen. It works there and displays like (I imagine) it should, but still doesn't display proper on the predefined Power page. Note: for my FTP, 421 displayed below is quite a bit into Z7, not just barely into it.
I'm not sure if this is relevant. At least I can make a workaround until the power page decides to start working for me.
