This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Data error during bike portion of triathlon

Former Member over 5 years ago

During the bike portion of a triathlon this past weekend, my watch stopped displaying speed/distance after .65 miles of the leg (cadence functioned just fine). The watch still measured time, and the GPS tracked the course (the bike was approximately 20.4 miles). I didn't have any issue during the swim and the run.

I'm not sure if this is a watch issue, or a failure of the speed sensor on the bike (I have the older version with the spoke magnet, possibly it slipped out of position?).

I have attached the file, in the event there is something salvageable.4058016088.zip

Thanks

Top Replies

Former Member over 5 years ago +1

Former Member

congratulations with the triathlon

had a look at your bike part

any idea what kind of speeds you were doing....got some real high ones after recalc

recalculated with FitFileRepairTool

nothing…
Former Member over 5 years ago in reply to Former Member +1

Former Member

the file in the zip is not processed

there were peaks above 50

recalc seems not to work here, perhaps while not one second recording

could cap all speeds above the low 30's

?
Former Member over 5 years ago in reply to Former Member +1

Former Member

no problem

check,replace the spd/cad battery

happy & safe sporting

All Replies

0 Former Member over 5 years ago

Former Member

congratulations with the triathlon

had a look at your bike part

any idea what kind of speeds you were doing....got some real high ones after recalc

recalculated with FitFileRepairTool

nothing done with the bike part

kiwimtnbkr would you mind checking