This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

My Garmin 945 can’t connect with Vector 3 via ANT. When adding new sensor, it only shows BLE option.

Former Member over 5 years ago

Recently I reseted my 945 because of battery problems. Now it can’t connect with my vector 3 via ANT+. When adding a new sensor, it only shows BLE. When paired via BLE, it won’t show cadence and can’t calibrate, shows error 0.

0 Browner40 over 5 years ago

Mine connects over Ant+ fine... no issues at all. Have you tried restarting your watch after the reset?

0 waltersjonathan over 5 years ago

Mine would only find BT sensors. Restart the watch again and see if that works.

0 Former Member over 5 years ago

I'm having the same issue. Can only connect to my Garmin pedals by BLE. Can't detect my heart rate monitor via ant+, only bluetooth. This started after doing a factory reset. Before the reset, ant+ was working fine. Anyone figure it out?

0 bbcgrrrl over 5 years ago in reply to Former Member

Having the exact same problem! Got 1/2 way through a Kickr workout and notices nothing was connected. Had to trash my whole workout, restart my Garmin 945, and now it's connecting to my external HR monitor but not my Garmin Cadence or Vector 3s. SO expensive and SO frustrating!

0 Former Member over 5 years ago

Has anyone resolved this issue? My Vector 3 connects to fēnix 5X and Forerunner 920XT, but the pedals would not connect via ANT to my MacBook Pro using ANT dongles (I tried using two different ones) when I Zwift.

0 CloggyAbroad over 5 years ago in reply to Former Member

Your issues is with the vector pedals or the MacBook, not with the 945 as there is no 945 involved. You might get a better response if you ask this in the vector 3 forum

forums.garmin.com/.../vector-3

0 Former Member over 5 years ago in reply to CloggyAbroad

I already did, CloggyAbroad.

Based on people's problem here, it appears that Vector 3 has some ANT issues. I just wanted to know how people resolved their problems to see if it is possible to apply a similar fix to my setup.

0 CloggyAbroad over 5 years ago in reply to Former Member

If your F5 picks it up then ANT is working. on your vectors. There is something wrong on the receiving side of your macbook.