This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Beta 2.48 chest strap connect via Bluetooth/ watch restarts

Former Member over 6 years ago

as soon as you want to connect polar h10 via Bluetooth the watch restarts.

Reproduced it several times - beta 2.48

please fix ASAP.

anyone else ?

Bests

0 iammario over 6 years ago

I had the same issue. You have to unpair your BT before upgrading. So what I did was downgrade to 2.4, unpair BT and uograde again to 2.48.

I retested the H10 with Ant+ works perfectly

0 Former Member over 6 years ago in reply to iammario

Perhaps it is not the unpair thing ? Perhaps it just works with ant ?

0 iammario over 6 years ago in reply to Former Member

Will try to re-pair with my H10 as BT rather than Ant+ on my next run

0 Former Member over 6 years ago in reply to iammario

Thanks / if Bluetooth fails it’s a massive bug

0 CloggyAbroad over 6 years ago

Not just the H10. I tried with a OH1 on BLE and it crashed as well.

0 SteveBUK over 6 years ago in reply to CloggyAbroad

Not sure if it helps at all. Ant+ Garmin HR monitor on Polar strap is fine on 2.48 beta.

0 CloggyAbroad over 6 years ago in reply to SteveBUK

ANT+ is not an issue. It's the BLE connection that crashes the watch. I have the OH1+ and that works fine on ANT+ but not on BLE. My H10 crashes the watch on attempting to make a BLE connection. Unfortunately I have not been able to upgrade the firmware on the H10 yet to include ANT+ connectivity.

0 iammario over 6 years ago in reply to Former Member

Yes confirmed. If I pair it with the H10 as BT, it will craah :-(

0 Fredderic over 6 years ago

Can also confirm, for me after my run it even asked (unprompted) if I wanted to add the H10, which I have paired via Ant+, via Bluetooth. Not sure why it thought it should prompt me with that, but i made the mistake and said yes, boom watch restart [2.48].