This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Tacx flux s Bluetooth and ant connectivity

Former Member over 4 years ago

I can connect my tacx flux s by Bluetooth to my tacx app fine. But when I try to then connect my fenix 6s by ant+ so I can record the activity in my garmin connect, it connects but the tacx app is then disconnected. Can anyone explain why please?

0 8320065 over 3 years ago

Have similar problem. Any advice?

0 2399282 over 2 years ago

Same problem,does anyone have solution?

0 Anthony over 2 years ago

I connected TACX Flux to the MAX Tacx App...then my Fenix 6 Pro to the Tacx App for HR. I then had all power and HR recordings. Once the activity was completed I saved and it went to Garmin Connect with all the data for load etc. I ensured my watch was not connected to the trainer as the trainer can only be connected to ONE output. I did this without the HR connection as well and I still got the activity into Connect however no Activity Load. HR connection was done from watch 'sensors and accessories/Wrist Heart rate/Broadcast HR 'on' and ensure broadcast during activity is set to 'on'