Tacx Flow Smart Stays at 0MPH

I was using my Tacx with Zwift but stopped cos my front wheel slipped. Adjusted the block but then it wouldn’t accelerate again? Tried to re-calibrate with the Tacx Training app. It connects and light is flashing green, but when I pedal, MPH doesn’t move?

0 Alex Masalovich 3 months ago

Check it:
https://support.garmin.com/en-US/?faq=faU1VcypD12GKsn0NMx9pA

0 PhilYogi 3 months ago in reply to Alex Masalovich

Thanks, I’ll give it a try. There is resistance but I did notice a slight gap in the casing?

0 PhilYogi 3 months ago in reply to Alex Masalovich

It wasn’t that. Duff product.

0 5385040 3 months ago in reply to PhilYogi

I also have a problem where I lose resistance. It tends to occur 20-30 min after spinning. The advice following the link above does not apply to my problem either. Help!!!

0 Luko79 3 months ago in reply to 5385040

how much "watt" do you produce during these 20-30mins? (if you are a heavy rider and easily ride with 250"flow-watts" or more, then it is not your trainer because overheating, it is a known problem with Flow, especially in ERG mode with low wheel speed, so with small ring front and an easy cog rear. the inner fan is working more effectively with higher wheel speed, but ofc the trainer is getting much more noiser in this case...)

0 5385040 3 months ago in reply to Luko79

Thanks for responding. I averaged 116 watt but steadily increased to 216 watt.
So is there any way to fix this, or will the drop in resistance and automatic pause continue to occur?
best, JS

0 Luko79 3 months ago in reply to 5385040

try to cool the unit with a fan placed close , sometimes it helps to stay below the critical inner temperature.

Btw, did you train with tacx videos and was it a hill climb where your unit shutted down?