This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SW 7.01 BLUE Triangle

I been running SW 7.01 for a while now. SW is a bit glitchy but today the clock froze on the blue triangle. A soft reset, or several did not help. I rebooted computer and clock prob 10 times. Finally i manged to get into this test check screen. Now clock has started, but this sounds like a bug to me, clock just freezing randomly.

I did press the upper right button for 15 seconds, then on. Did not help 1 time, had to do it many times... But back online now ....

0 Mr-Henrik over 2 years ago

Got clocked working, but it continued to go to SW test. Managed to put Garmin 6.90 installation file on clock, it installed but now the device is dead and stuck on blue triangle. Crap Also worth mentioning, when I managed to get the clock into "desktop mode", first layout and go into menus, right bottom button on clock did not respond.

0 4411990 over 2 years ago in reply to Mr-Henrik

I Can't wait until they force this disaster upon us.......

0 Mr-Henrik over 2 years ago in reply to 4411990

I got a theory that i took a swim in the ocean and since the clock was a couple of years old the glue or rubber gasket was not sealing clock 100%. From all the threads on internet, i read that the blue triangle occurs when system memory has defects. ROM/RAM test did pass, but i am not trusting those readings were accurate. I did scrap my vivoactive 4s on sunday and got a Venu 2S. Life goes on. I wish however Garmin would use more screws instead of glue.Both on vioactive 4s and venu 2s, its impossible to replace the battery after a few years...