This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Missing club when pairing 14th sensor CT10

I just bought the 14-pack of the Approach CT10. When I am pairing sensor 1-13, I can see all my clubs; however, when I am down to the last sensor, the 14th club disappears. I tried everything:

Deleting the club and adding a new one
Removing a previously paired one, add the one missing (two available show up at this point), pair the one that was missing and go back to pair the one that was already working,.. At this point that club disappears and it can only be "unassigned"
Uninstalling the application and installing it again
Resetting the phone, the app, etc.

Any insights? Thx!

0 avargasy over 2 years ago

I figured it out. My 14 set has 2 lloft wedges (56 & 60 loft). It looks that is what is causing the issue. I can pair one loft wedge, but not more than one. I hope this can be in the backlog as an enhancement: to enable any mix of 14 golf clubs.

As a workaround, I created a hybrid loft wedge in the equipment section of the Web Garmin Connect; however, this cannot be seen on the Golf App in iOS. I can pair it on the watch, but cannot see it on the app. I give up

*** Update *** Used 1 iron. I will never use that club and now I can see it in the iOS app as well.

Garmin - It would be great to get this fixed.