This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Venu and Training Peaks

I had a Garmin 235 where my training sessions worked perfectly, I would get a "Fast/Slow" alert during my run to keep within the pace required.

When I tried to run a TrainingPeaks workout using my Venu that doesn't seem to work at all! I get an annoying pace alert every few seconds but no alert about whether I need to speed up and slow down.

Has anyone been able to solve this?

0 DCO over 3 years ago

I am not familiar with Training Peaks workouts specifically on this device, but I have done several workouts which included pace ranges. It has vibrated to notify me when I am below the target pace range, above, and even a subtler vibrate for when I am right in the middle of the band and have sustained it for a few seconds.

0 carlosdmesteves over 3 years ago in reply to DCO

Is this the sort of screens you get as well?

Before starting: https://ibb.co/q1zBbwP

During run with a controlled pace: https://ibb.co/m6Lwxky

The annoyin pace alerts that I mentioned: https://ibb.co/NYWsYWx

When the pace alert comes up, it doesn't tell me whether I need to slow down or speed up as my old garmin would say.

0 DCO over 3 years ago in reply to carlosdmesteves

Ah! I see what you are saying now. Yes, it is the same for me. The screen that shows “pace” does, in fact, not have the red/green zone graph at the top. It would be nice if it said “speed up” or “slow down”.