This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Varia UT800 disconnects from Edge 1030 with every charging

Usually I am charging all the gps, front light and the radar after every 4-5 rides (roughly 20 or so hours activity).

I did not pay attention earlier but lately a night before a ride I need to do an exercise to form a light network because the front lite most likely will disconnect.

Sometimes I was disconnecting the radar as well and add each back manually to the "network". This thing getting boringly annoying.

No disconnects in between charging only after I charge specifically the UT800.

I even connected to PC, GExpress to see any new software for it, the UT800 sits on ver 2.4, the RTL510 is on ver 3.7 and the Edge 1030 device software ver 12.0

Any better tricks to keep it connected?