This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Varia Vision total ascent goes to 0 during ride

temoore48
over 7 years ago
Total ascent works fine for the first part of the ride, then at some point it starts showing 0. Garmin 1000 still showing correct total ascent. Just did reset of Vision, but haven't done a ride since. Anyone else have a similar issue? Thanks
  • 0 over 4 years ago

    Same problem with Edge 530 running 7.10 and Vision running 3.6.0.  

    As soon a the total ascent reaches 527 ft, the next increment will be 0 or 1 on the Vision.

    Reseting the Vision does not help.

    I wish Garmin would spin a final 'final' firmware on the Varia Vision.