This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Auto Pause/Resume not working with RK200 pedals

Hi-

Picked up some Rally RK200 pedals the other day. Batteries good, Installed okay, updated firmware via Garmin app, connected via ANT+ to 530 head unit and calibrated.

Configured auto pause on 530, started ride but timer stops after 2 seconds and will not resume. Manual and custom speed did not work either. I am indoors and have not tried it outdoors yet.

Note that auto pause/resume has always worked fine using same 530 head unit with powertap G3 hub and stages single crank indoors or outdoors.

Besides new batteries I can test tomorrow, anything else I can try or am doing incorrectly.

Thanks.

-chris

0 4957929 over 1 year ago

Update:

- Performed initial install indoors and by-cranking pedals. Likely did not reach 6mph minimum speed before it auto starts again. Outdoor ride confirmed this.

Moving forward:

- 'Calibrate before every outdoor ride.

- Swap out batteries if problem persists.

-chris