This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

power zones

Hi,
I use rally rs200 and EDGE830 pedals.
For some time now, in the power zones in the GC in zone 7, I have a very low value. In other apps it is ok. differences are 0:45 sec to 3 min in Strava or TP.
After consulting with Garmin, the pedals went back to Garmin for testing.
Do any of you have a similar problem?
In my opinion the problem is in the GC and not in the pedals because other apps on their .fit file show a good value.

The question is if there is an incorrect value in the power zones is it calculating well: load, avr. watts, NP, TSS? I am not sure now that these are good values and they affect many other things

0 2099884 over 2 years ago

Hello. I recently bought new power pedals. I also have a problem with the power zones not displaying correctly. When I do a hard workout, the GC shows that zone 7 means <150 watts which is incorrect. At the same time, the average power for the ride is 182 watts.

Is there anything I can do that I haven't already done? Take out the batteries, reset, latest firmware, etc.

0 kielak over 2 years ago in reply to 2099884

Yes, pleas open your Edge and change power zones. 7 zone is not sync GC, I dont knowe why :-/

In my Edge 7 zone is 150-156%. I wrong. I'm change into 150-1500% and works good.

0 Garmin-Maeve over 2 years ago in reply to 2099884

Do you have a screenshot of what your power zones look like in your account or device settings?

0 kielak over 2 years ago in reply to Garmin-Maeve

I have only screen GC. In the application it looks good, in edge "zone 7" was entered 150%-156%. I've already changed it to 1500%

0 kielak over 2 years ago in reply to Garmin-Maeve

0 2099884 over 2 years ago in reply to kielak

It looks like the problem is solved but I'm still a bit doubtful. 

Vector 3 and Rally are almost the same garbage in my eyes, just a new name.

0 kielak over 2 years ago in reply to Garmin-Maeve

Garmin-Maeve

The problem returned after the 9.50 update

I had the "zone 7" range set to 150-1500%

After accutalizcaji "zone 7" was changed automatically to 150-150%

Unfortunately I saw it after the next drive.