This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Indoor cycling with course is broken with 18.23

3521843
over 1 year ago

Hello, 

I've recently updated the firmware and maps to 18.23 version. However I get and issue with i do indoor cycling.

I've created couple of courses, which are long enough and there are climbs for sure. I load those courses on my Edge 840, and start to cycle on my indoor trainer. Edge 840 regulates the slope, i can see the virtual location of map, however the graph showing the climbs is shown as it was with firmware 9.26.

What should i do to get the current graph of the slope to be shown as something like this:

 Many thanks

  • 0 over 1 year ago in reply to 3521843

    Likely because, like mine, it has reverted to the free ride Elevation screen (not course) version which does not have a cursor or VP as your position is always on the far right edge, you can tell otherwise as it only has a "Total Ascent"  rather than TTL Ascent & ASC Remaining on the top

  • 0 over 1 year ago in reply to aweatherall
    aweatherall said:
    I'm able to produce the issue with the elevation page being blank. I have raised a support call with Garmin.

    The same thing happens with the Climbpro screen when following a course on the Indoor Profile, no elevation profile

    And same continues with 18.25, I spend a lot of time following a course Indoors on the trainer and this BUG makes it completely pointless.

  • 0 over 1 year ago

    There is a new beta version 19.08 today for 540, 840, 1040 that says it includes 

    • Fixed elevation page and ClimbPro for indoor trainer course use.

    I have done one brief test with this and the issue appears to be fixed at least for the elevation screen, I have not yet tested climbpro