I'm creating my workout in Training Peaks using %FTP as a TARGET. I tried Garmin Connect but there isn't an obvious way to create a target power workout. If I load this onto my recently retired Wahoo Elemnt it shows the target power for each step of the workout. If I load this onto my spiffy new Garmin 830 it will only show a range. In action it does not hold a target power. My goal is to be in the middle of a zone, say zone 2 for example, but in reality, it drifts between the upper and lower limit of the zone and I'm spending a substantial amount of time in Zone 1 & 3. I tried creating a workout with a very narrow zone, about 1-2 watts but it still drifted up and down. I might add I'm doing my best to hold a steady Cadance. I'm a below knee amputee so I have a bit of imbalance.
Questions: Is there some trick to telling the 830 that I want it to use target power, NOT a range? Any other suggestions to achieving this goal? Is there a way to create a target power workout in Garmin Connect.
Controlling my trainer va ANT+ (not BTE) was a major reason I bought the Edge. I seem to have a worse problem now. :(
