This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

520 edge + end point problems

Hi, I am using a 520 edge plus. I have uploaded a route from strava and tried riding it 2x, however in the middle of the ride a the same location the unit says course end point and stops navigating. Its a loop and when in garmin connect the start and end points are the same and there is no course point where this happens.

Very annoying problem.

Anything I can do to turn this off?

0 pgrigorenko over 3 years ago

Same for my 520+, at about 16-17.5km it shows an End Point and then starts recalculating something which affects navigation (e.g. turn alerts disappear, etc)

0 1849422 over 2 years ago

Yes, I'm having similar problem. 530 tells me Finish is in 700m when I've many ks to go. Reloading the route fixes it but sometimes only for a few k. Only started happening since latest update to date of this post.

0 Artem over 2 years ago

guys, try to post this in the right branch. then you'll have more chance for helpful answers, I think