This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cycling Dynamics with Rotor 2InPower Cranks and Fenix 5

Hi, my Rotor 2InPower cranks offer cycling dynamics, but when the data is collected by my Fenix 5 and downloaded, only L/R, Power and Cadence is displayed.

Is there a setting I need to activate to get the full read-out?

Top Replies

Luko79 over 4 years ago in reply to Gaugeler +1 verified

the F5 finds the 2inPower on both protocol (so You should have 2 powermeter sensors in the list), so You need to go into the sensor details, and checking which protocol is used, delete the BT one and use…

All Replies

0 Luko79 over 4 years ago

Do You pair it via ANT+ or BT? Because if via BT You will have only these 3 metrics (balance, power and cadence...).

But it is an Edge 830 forum...

0 Gaugeler over 4 years ago in reply to Luko79

Hi, thanks. I didn't realize its an edge forum. I will post in the appropriate forum, thanks.

btw, It's my Fenix and I don't know how to pair with BT or ANT+, it just connects

+1 Luko79 over 4 years ago in reply to Gaugeler

the F5 finds the 2inPower on both protocol (so You should have 2 powermeter sensors in the list), so You need to go into the sensor details, and checking which protocol is used, delete the BT one and use the ANT+ version only