This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Climb Pro: erro quando acabamos por não seguir o percurso programado, mesmo depois de terminar o seguimento no aparelho !!!!

Ruimmf1
over 5 years ago

Tenho um EDGE 830, com software 4.10

Ontem tinha programado este percurso:
https://connect.garmin.com/modern/course/26878796

mas depois, por sugestoes de amigos de pedalada, fizemos este:
https://connect.garmin.com/modern/activity/3935881400

Logo no inicio do passeio terminei o seguimento do percurso que tinha selecionado. Mas estranhamente foram-me sempre aparecendo no aparelho as subidas no ecra Climb Pro como se eu estivesse a fazer o percurso que tinha antes programado, o que não estava a acontecer !!!! As subidas não correspondiam minimamente com a realidade da estrada, e não consegui que me deixassem de aparecer, até que alterei o perfil e desliguei o ecra Climb Pro....!!!! 

O aparelho deveria conseguir reconhecer que nao estamos a seguir o percurso que foi programado e não apresentar  as subidas, se não as estamos realmente a fazer.

Mesmo terminando o seguimento do percurso no aparelho, continuaram-me a aparecer as subidas do percurso programado :::!!!!

  • Former Member
    0 Former Member over 5 years ago

    It is a common courtesy to write your posts in English.

  • 0 over 5 years ago

    Google translation if you are intested.


    I have an EDGE 830 with software 4.10

Yesterday I had programmed this route:
connect.garmin.com/.../26878796

but then, by suggestions from cycling friends, we did this:
connect.garmin.com/.../3935881400

Right at the beginning of the tour I finished following the route I had selected. But strangely, the climbs on the Climb Pro screen were always appearing on my device as if I was doing the route I had previously programmed, which was not happening !!!! The climbs did not correspond in the slightest with the reality of the road, and I could not stop appearing until I changed the profile and turned off the screen Climb Pro .... !!!!

The device should be able to recognize that we are not following the route that has been programmed and not show the climbs if we are not actually doing them.

Even ending the tracking of the route in the device, I continued to appear the climbs of the programmed route ::: !!!!