This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Map frozen (for couple of minutes)

hi there,

every time i start a new course the map is frozen for couple of minutes. i can see the VR moving ahead whilst i stay put, touching the screen or swaping through the screen-modes (using di2 buttons) gives me a brief update, but then again frozen, eventually it comes to its senses, but if i need navigation at the start of the route is annoying. on 820 i didn't have to wait for the route to be calculated, i could already simply follow the route albeit without navigation (till calculation was complete).

does everyone have this or i need to send my unit to service?

Cheers,

Dorin

0 Jaran over 5 years ago

Same for me. It updates the position for a few moments and then freezes while calculating the route. Once the route is calculated it and very seldom even in between it updates again.

Software version 3.55

0 dorin_boca over 5 years ago in reply to Jaran

I got mine replaced under warranty

0 ZillaG over 5 years ago

Mins did this today, 1 month old, latest firmware.

0 Ranger over 5 years ago

Have the same problem with my unit. This only happens with pre-drawed courses, if I use Go To Point navigation, everything is OK