Edge 540 - Climb pro: wrong start and end of a climb

Hi, on my new Edge 540 I enabled the Climb Pro feature and calibrated the device appropriately (compass and altitude).

I'm disappointed because the start and end of the climb reported by the Edge are always wrong: the Edge reports the end of the climb long before the actual end.

How can I correct this behavior?

Thanks for your advices

Top Replies

8180015 3 months ago +2

Same problem here too. Climb has definitely started physically before Garmin says "Climb!"
S01 3 months ago +1

When climbing, I find GPS modes other than the highest accuracy may drift a bit, check that setting first. Another problem is Garmin's elevation data seem less accurate in some areas, in my case, China…

All Replies

0 3790937 3 months ago

I have the same problem

0 8180015 3 months ago

Same problem here too. Climb has definitely started physically before Garmin says "Climb!"

0 S01 3 months ago

When climbing, I find GPS modes other than the highest accuracy may drift a bit, check that setting first. Another problem is Garmin's elevation data seem less accurate in some areas, in my case, China mainland. So I used Komoot to plan a climbing course, giving Climbpro better accuracy.

0 russellsl 3 months ago

I have the same problem. Garmin Edge 540 consistently reports incorrect start and end of climbs.