This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

performance condition missing

jimtames

Performance confition is enabled and the data field added. Notifications are enabled. Data field stays as "---" during a ride. This is the case for Z2+ rides, not just Z1.

This was with 9.10. Have installed 9.28 beta to see if that improves things.

Same thing is happening on fenix 7, performance condition is enabled but not showing any data.

Heart rate and power sensors are connected.

Performance condition chart is not visible on garmin connect. 

  • +1

    PC requires your HR to be above 70% of maxHR for several minutes. I would suggest carefully checking your maximum HR settings in Garmin Connect, and if necessary change them. In fact, I would recommend changing them to something else in Garmin Connect, syncing to your Edge/F7, then changing it back and syncing again.

  • 0 in reply to mcalista

    That's not the issue. I rode a crit yesterday at 90% of maxHR for 30 minutes and it didn't show. I will try the change/sync though, as that might unblock the issue.

  • 0

    It's back - the only material change on the fenix7 was changing max HR and HR zones in the iOS garmin connect app. For the Edge 530, I went to the 9.28 beta but also changed the max HR/zones and synced, so it could have been either.

Copyright © 1996-2025 Garmin Ltd. or its subsidiaries