This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Edge 530 Starts with menu "Burn in Test "

9646783 over 2 years ago

Hello,

My Unit Starts with an Unusual Menu:

Burn-in Test

BI test Check Sum

General Information

Memory Test

Key Press

Display Evaluation

Beep

ANT Sensors

....

What is happening ???

appreciate any help!!!!

0 oBuTTuSo over 2 years ago

Maybe some button is stuck and pressed in during start?

0 nord0296 over 2 years ago

On some past units I think the Start button being held or pressed when the unit is powered on caused a Factory Test mode to be run. I don't have my device on me to check this for the 530, but I would also suggest turning it off, checking that no buttons are pressed or stuck and then turning it back on.

0 9646783 over 2 years ago in reply to nord0296

Thanks for your help . The Unit is definitely stoked on factory test mode ...

The Start button is not pressed on start ,I can I get out of this ? Via PC ?

0 Rob_Swinnen over 2 years ago in reply to 9646783

Have you been able to fix this? I have the exact same issue

0 9646783 over 2 years ago in reply to Rob_Swinnen

Hello Rob,

No fix was found! Garmin replaced my Unit under warranty!

Perfect service :)

Antonio

0 Rob_Swinnen over 2 years ago in reply to 9646783

Thanks for the info! I’ll contact Garmin and hope I’ll get the same service then :-)