This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ant+ not pairing any sensor

This all started when I purchased a new stages power meter. I could not get it to pair . I have looked at the previous comments and tried everything.

1. Done a reset (3 times). Discovered that none of my sensor were pairing on any bike. HR, Quarq PM, 3 x Stages, Vario lights

2. Checked firmware (6.20)

3. Checked batteries on all sensors (all good). Head unit fully charged

4. Disconnected from Garmin Connect. Deleted device off Garmin Connect

5. Sensor pair with Ant+ dongle (Trainer Road)

6. Moved head unit closer to sensors

7 Waited for more than 3 minutes -Small wheel spinning in top left corner -not pairing

Thoughts???

0 etmbejo over 3 years ago

The menu is extremely user-unfriendly and lacks a confirmation. You just need to leave the menu by moving the cursor up or down and the sensor will be stored.

0 dtoleman over 3 years ago in reply to etmbejo

OMG! It is not obvious from the instructions that is how you complete the pairing. Thank you. All paired now