This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Respiration, Training Load, Heat not recording after 3.50 update

Since I updated to 3.50 software on June 30 my Edge 530 no longer reports Respiration, Training Load, or Heat acclimation information. I have performed a factory reset, deleted and re-pair with my phone but still not recording. I have ridden same routes post and pre-update so don't think the non-recording is due to a mileage, elevation, etc. matter. I use a Wahoo heart rate monitor that is connected via ANT+. Tough situation to debug because all was fine during first 10 days of use and typically a factory reset for tech hardware puts matters back on track.

0 Former Member over 6 years ago

Same thing happend to me on my new Edge 830 when updating to v3.50. Kinda strange that noone has replied to you in 5 days..

0 henrikabild over 6 years ago

Same thing happend to me on my new Edge 530 after updating to v3.50. Help is needed for getting this back.

0 sylverwolf over 6 years ago

Same thing here, it was fine on the first couple of days but then I did a factory reset to fix something else and since then respiration, training load, recovery, stress, etc are not working...

I'm thinking of sending back the unit and get a new one.

0 sir_lambo over 6 years ago

Same here and also V02 max no longer transferring to Garmin Connect. Issue not fixed with 3.55 Beta.

They are reported on the device itself (except heat that seems fully gone) but they are not properly synced.

0 Tim_B_ over 6 years ago

Have you guys actually logged a job with Garmin support, or just mentioned it here?