This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Power Meter Calibrates but Power Readings are Sporadic on 130+ but OK on 1030

A few times this has happened to be my 4iiii PM has connected instantly to my 130+ but refused to read power until I turn 180deg to home a minute later it then shows Watt's for a bit until I free wheel and turn and then it does the same again.  After a few spins round the block repeating this no reading/ reading process I go home and swap to my 1030 and it reads fine.  The 130+ was working fine with the 4iiii two days ago and I suspect it will again.  Has anybody any idea what is going on ? as I prefer the 130+ for training and racing.