This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

elevation plot blank

Running version 2.50 on Edge 130+

Whilst either running an activity or following a course the elevation plot is blank. In both cases I was riding for 45+ minutes so plenty of time for a plot to appear.

Anyone else experiencing this?

0 WalterB over 4 years ago

The 130 has/can have the same problem, check the 130 forum.

0 tmiller over 4 years ago

my 130 plus is working as expected fyi, firmware version 2.50. dependent on me being in "navigating a course" mode and the hill being "big enough" to show. for instance, a 500ft vert / 1.2 mile hill on an activated course shows up just like the images in the manual. the ClimbPro data screen jumps to the front, I can page out to other data screens and page back into it. yesterday I was notified to install firmware 2.60, but haven't been out with the new version yet to test it as well.