This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reboot and stop recording when recalculating the route with version 29.22

giuze

That happens already 3 times where the Edge 1050 had to recalculate the tour. It stops, reboot and then didn't start the tour automatically.
Sometimes the recalculation work perfectly.

The last time it happen, I was followint a course, the decided to shorten the ride and to navigate to the start using the shorter route.
When it had to recalculate as I was avoiding a closed road, it rebooted. Then I could see the route but didn't realised it stoped recording.
Only at the end when I wanted to stop it, it started recording instead. So I had a straight line at the end.

  • 0

    I had exactly the same issue/behaviour on a tour today

  • 0

    I hope they will solve this issue soon. I had some crashes with previous firmware but never those reboots while recalculating a tour.

  • 0

    I had exactly the same problem yesterday. Furthermore, in addition to the rebooting, it couldn't recalculate the course when avoiding a road in the middle of a Garmin segment.

  • 0

    OI have the same issue using routes (imported frem Strava), never had this issue before 29.22

    After recalculating, I can't switch screens or use the bell. the 1050 still records the effort, milage elevation and so on.

    Yesterday it happend again, the after a second recalculation the functions came back, but after third recalc it froze again.

    Very annoying, just wrote to support, they did not have a case on this issue. I will open one

  • 0

         I sent you all an email regarding this issue. Please respond to it directly if you have any questions! 

     I saw that you've been in contact with Garmin Denmark Support about this. Please respond to their latest email at your earliest convenience.