This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Firmware 28.20: Instantly reboot after selecting recalculate route

Yesterday, during a 50 km ride, I followed a track created with Komoot. At some point in time there was a deviation due to roadworks
and the Edge 1050 presented me two options: To pause navigation or to recalculate.
When I selected recalculate the screen became black instantly and the device rebooted.
After the reboot I still had the original track visible and no information was lost. So I went back to the track manually and continued from there.

Release 28.20

Top Replies

Jurva 3 months ago +1

The problem is the 28.20, it seems to reboot (collect diagnostics it says with small print) for what ever reasons, you are lucky it is done only once and works well after that. Strong recommendation to…

All Replies

0 Jurva 3 months ago

The problem is the 28.20, it seems to reboot (collect diagnostics it says with small print) for what ever reasons, you are lucky it is done only once and works well after that. Strong recommendation to roll back to previous firmware (if that is possible, I am not yet sorted out is that doable)

0 JaroslavSedlacek 3 months ago

I have the same issue with 28.20 - luckily only once yet. When I diverged from my route significantly it started recalculation and device rebooted. The activity continued after reboot which was fine.