I have the 1040 (non-solar) and 4iiii Precision 3 power meter, both on latest (beta) firmware.
I've noticed the last couple of rides that while the power meter does connect fine, the power shown is always 0. I've tried stopping for a few seconds, even calibrating and nothing helps. The only trick I've found is if I stop for 2 or 3 minutes, then the power suddenly starts reading correctly.
Not sure where to look further. I kinda doubt its the meter itself since I've been using it with no issues for a while now, with two different bike computers.
Any tips on what I can try to fix this? Thank you!