This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No distance remaining when navigating to a point

Hi,

When navigating to a point, none of the distance fields are showing the distance either remaining or already done. Maps are updated, SW is updated. Any ideas?

Best regards,

A. Duarte

0 aweatherall over 2 years ago

Was the timer started by pressing the bottom right button?

0 aduarte over 2 years ago in reply to aweatherall

Yes, always during an activity started, Always zero distance.

0 aweatherall over 2 years ago in reply to aduarte

Can you post the FIT activity file?

0 aduarte over 2 years ago in reply to aweatherall

Sorry, tried to upload the fit file but didn't succeed. Anyway, the point is whenever I am navigating to a destination I have no distance remaining info (always 0)

0 aduarte over 2 years ago in reply to aduarte

Problem solved. Should have selected distance to destination.

0 aweatherall over 2 years ago in reply to aduarte

Yes the 1040 does not use "Distance to Go" in the same way as the x30 units do, so you will only get the value in the "Distance to Destination".