Still no automatic connection to Rally power meter

i have rally 200 a everything ok ..

As I posted in another thread and based on one ride:

I have the XC200 on V4.0 firmware.  This is morning I rode my MTB.  I turned on my E1040, spun the pedals a few times with the E1040 on the home screen.  The XC200 connected message came up followed by the calibration prompt.  Everything worked as expected.  Next I chose the bike profile and started the ride.  Everything worked fine for the entire ride.

mutnig are you connected to the pedals over ANT or BLE? Have you tried deleting the pairing and re-creating it?

It is connected over ANT.

History: sold my 1030 and bought the 1040 Solar, setup over IPhone App: all sensors were transferred to the 1040 - but did not get a connection to the Rally, removed all power sensors (due to Q-issues had 3 Rally pedals), and searched for sensors and connected the actual pedals.

Since then I did not again remove the sensor.

every time the same: after pedalling Edge shows “Disconnected”….

But when connected and pedals got to sleep during a brake, no issue when I start again: after a few seconds Edge shows the power. 

Dear all, 

today i updated the rally XC200 to the latest SW (4.10), Edge 1040 Solar is on 15.24 - still no automatic connection of the XC200.

Performed a complete reset on the E1040 skipped all connection and backup requests, searched for sensors and connected (HR, Speed & Power) them.

After power-off and some minutes, I powered the E1040 on again, it connected immediately to the HR sensor, after spinning the wheel to the Speed Sensor, but not to the XC200 - Sensors shows "Disconnected"

When selecting the power meter and typing the connect button it ask for calibration and can be used.

Does anyone have an idea how to solve that issue?

thx

Helmut