This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New Edge 1030 Plus Public Beta 5.63 Now Available

A new Beta software for the Edge 1030 Plus has been released. Full change log, instructions, and software for installing the beta can be found in the link below.

Edge 1030 Plus: https://www8.garmin.com/support/agree.jsp?id=15682

Notes:

For any issues that you encounter please fill out the form included in the download and attach it to an email to [email protected]. Please note that you may not get a response to the email unless we need more information on the issue you report.
Although this software is believed to be reliable, it has not yet been released for production and should be used at your own risk.

Changes made from version 5.20 to 5.63:

Fixed device-to-device transfers
Added new tone for radar that that plays when your radar transitions to the green threat level. Go to the radar settings in the sensors menu to enable this feature.
Improved bike light network connection stability
Improved course point display and added new types
Improved Course 'Always Show' functionality
Improved shifting sensor battery data fields
Improved Physio True-up data recording
Improved indoor trainer control
Fixed issue causing unnecessary sensor software update prompts
Fixed power calibration prompt when waking from sleep mode
Fixed history line color
Fixed issue with left/right power balance recording
Fixed issue with GPS not turning off in indoor mode
Fixed the power graph during workout steps with no power target
Improved general device stability

0 Microkid over 3 years ago

75km ride with 5.63, no problems. No Varia 515 disconnects. Could not find the "all green" beep setting, will try later.

0 Johneed over 3 years ago in reply to aweatherall

Hi. I have a sram axs 1x drive train but the gear battery field shows the rear mech icon but not the shifter batteries?

0 krazyeone over 3 years ago in reply to Microkid

Option is pop ing up after first firmware install/reboot and for sure it cand be changed in radar settings

0 ludo-vick over 3 years ago

Error when using return to start point (error to calculate à road)

0 wflicht over 3 years ago in reply to ludo-vick

Same when starting to navigate: go to start point => calculation error. After clicking the error message disappears and all works OK.

0 VooD007 over 3 years ago in reply to aweatherall

Hello, is SRAM AXS seat post battery supported?

Regards

0 aweatherall over 3 years ago in reply to VooD007

So I looked at the data being sent by the SRAM axs 1x system.

SRAM reports that there are 3 batteries, but they then only send the status of the RD battery.

Not sure why this is as they send the status of all batteries on my older 11 speed system,

0 MGMATE over 3 years ago in reply to aweatherall

Hi aweatherall, Did you have the chance to check it out?, I guess not, but just to be sure.

0 aweatherall over 3 years ago in reply to MGMATE

So the ANT protocol does support passing values for 2 power meter batteries. I have no visibility on whether Garmin plans to show that information on the Edge.

I guess this would have more value on systems with rechargeable batteries where you could recharge them differently.

The life difference between the left and right disposal batteries is small enough that I think you would always replace both at the same time.

0 BMC - Josetxo over 3 years ago in reply to aweatherall

En el caso del Di2 de 12 velocidades, la batería principal, la de los cambios, mostraba su carga mediante un porcentaje antes de la actualización. Es mucho más gráfico que el pictograma de barras. Ya sé que ahora se muestran las baterías de las manetas, pero sería bueno diferenciar la batería principal y mostrarla como antes en %.

Gracias