This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After upgrading to version 5.0, I constantly get "New Inreach Device Found".

This started happening after the 5.0 upgrade. I have a 1030 and also the mini Inreach. They are both synched. During my ride, I constantly get a beep from my 1030 and it says "New Ireach Device Found" (or something to that effect, forgot the exact wording). When I go into the settings/Sensors, it shows my Inreach is connected. So the next day, I left my Inreach at home. But the 1030 still kept beeping and saying "New Inreach Device Found". It did this several times during my ride. Sometimes several times within a minute, and then it stops for an hour. Is there a fix for this? Thanks!

Top Replies

PeterRichter over 3 years ago +1

My Bontrager Speed/Cadence sensor kept popping up, but it was still logging the data the whole time. I tried removing the sensor, then adding it again, also tried rebooting mid-ride. These updates are…

All Replies

0 thuhtama over 3 years ago

I have a similar issue. Every time I stop even for a minute and start moving again, I get a beep and "AXS Device / Shifter Found". Happens on every bike that I have AXS shifters.

0 Frodziak over 3 years ago in reply to thuhtama

I have the same problem with Shimano Di2 since upgraded to 5.0

0 PeterRichter over 3 years ago

My Bontrager Speed/Cadence sensor kept popping up, but it was still logging the data the whole time. I tried removing the sensor, then adding it again, also tried rebooting mid-ride. These updates are so annoying! Every time it's something.

0 Mrburns over 3 years ago in reply to PeterRichter

This is an interesting thread. I hope Garmin are reading it.

This week my 1030+ V5.0 decided after 40K to just keep searching and finding all my sensors. It did this about 10 times before I was forced to switch the unit off and then reboot and start a new recording.

Most annoying