This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

1030Plus FW 4.19 beta - peripherals randomly disconnect and reconnect.

During a 2.5 hours ride all connected peripherals (RTL515, speedsensor, cadanssensor) randomly disconnected and reconnected a few times.

IMHO it is much worse than with FW 4.10 and FW 4.18 beta.

Top Replies

mcinner1 over 4 years ago in reply to lovesickoyster +1
lovesickoyster said:
Is there anywhere I can send the file(s) to help diagnose this?

Simply read the download notes:

Notes:
- For any issues that you encounter please fill out the form included in the download…

All Replies

0 Microkid over 4 years ago

I did a ride today with the FW 4.19. None of my sensors disconnected (RTL515, garmin speedsensor, 4iiii power- and cadence sensor)

0 ccparkhill over 4 years ago

My radar disconnected a couple of times today on 4.19, saw my speed sensor disconnect too. 4.18 was fine.

0 RVASSEN over 4 years ago

Same here. Did a 6 h ride and had lots of random disconnects of my radar and the edge remote.

Navigation had a few issue too. Was following a route and everytime I left the calculated route the edge showed route calculation errors.

0 lovesickoyster over 4 years ago

I've had everything randomly disconnect yesterday (speed, power, radar and di2) for about 10 seconds before it was reconnected. Is there anywhere I can send the file(s) to help diagnose this?

0 mcinner1 over 4 years ago in reply to lovesickoyster

lovesickoyster said:
Is there anywhere I can send the file(s) to help diagnose this?

Simply read the download notes:

Notes:

For any issues that you encounter please fill out the form included in the download and attach it to an email to [email protected]. Please note that you may not get a response to the email unless we need more information on the issue you report.