This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Light network issue

Hello,

I moved from a edge 530 to a 1030 plus. When I try to re setup the light network with VARIA 510 and ION 200 RT it doesn't work.

I've tried different sequence of pairing, with some impact on the light detection, but none result in a proper network and stabilized experience.

Please help !

0 spiderbundy over 3 years ago

Did your sensors get added automatically when you set up the 1030+?
All my sensors got set up straight away from my Garmin Connect account. The only issue I had was the lights. All my other sensors connected fine but with the lights I had to Remove them and then re-pair them again...the light network then set up fine.

0 AntoineG over 3 years ago in reply to spiderbundy

Yes, all sensors were added.

Same as you, light issue, but I tried to delete, re-pair, etc. Still not working.

0 AntoineG over 3 years ago

So ... I finally decided to perform a full reset. After a new migration using my phone ... It works ! I stop touching anything now !

0 solarx6 over 3 years ago

Same problem. Repaired Varia RTL510 and UT800. But light network is not working/forming.

0 AntoineG over 3 years ago in reply to solarx6

Did you try to factory reset and redo everything. It worked for me.

0 solarx6 over 3 years ago in reply to AntoineG

I’d rather wait for an update. I hate spending all the time to rebuild everything. Just had to do it on my Fenix 6. So I’m done with that for 2020

0 AntoineG over 3 years ago in reply to solarx6

You have nothing to do, save the .fit files on your local folder and paste it after.

The 1030 plus is fresh new, no beta yet !