This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

1030 Plus arrived with Varia Vision sensor in the sensors list

After setting up my new 1030 Plus I noticed "Varia Vision" with ID 619879 in the sensors list. I never had Varia Vision.

Has anyone faced this or my device was previously used?

0 aweatherall over 5 years ago in reply to aweatherall

Did you remove the visions from the sensor listing before you sent me the file?

0 9257754 over 5 years ago in reply to aweatherall

Nope, they are still there. I also see them in the file I sent you - they listed with ID's 115145 and 619879.

0 aweatherall over 5 years ago in reply to 9257754

I'm thinking that they are associated with the use of the Extended display. Did you ever set-up the extended display on your Fenix 6

0 9257754 over 5 years ago in reply to aweatherall

I did, but Varia Vision appeared before that, right after first initial setup of 1030 Plus. I tought it could be somewhere in the firmware where all existing sensors are copied from old Edge.

0 aweatherall over 5 years ago in reply to aweatherall

An extended display would show on the Edge as the HMD (Varia Vision).

You can just delete them and they should not reappear unless you go through the process of importing the sensors again.

0 9257754 over 5 years ago in reply to aweatherall

Alright, but I still consider this a bug. If you are right it makes sense to call it Extended Display, it's definitely not Varia Vision.

It's possible that it somehow got imported from my old devices Edge 520 Plus and Fenix 5 plus.

0 JacekThomann over 5 years ago

Hi, My new Edge 1030Plus got the same thing, Varia Vision was visible in the sensor list.