This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

1030 Plus starts Activities while being stationary – HowTo fix?

Hello,

received my 1030 Plus yesterday...

I have an issue that I did have before (some years go with an 800 or so – but that was fixed by firmware or perhaps a re-configuration (setting)):

I have set an Auto-Activity threshold of 10km/h which has always worked for me. While being in my house or e.g. pushing the bike on the way to the street before riding the device does not start the activity. Once I reach 10km/h the activity start in the old Garmin. The new Garmin starts on it's own – it's laying in front of my on my table and activities start – kilometres "done" are quite high.

Pleas find attached two screenshots.

Any idea on how to solve the issue?

Best, Lorenz

0 7119966 over 4 years ago

Yes mine does the same i

0 6362807 over 4 years ago in reply to 7119966

Same here. Constant lost and find satellites inside. For now I start rides manually.

0 raskinner over 4 years ago

Mine is doing the same thing

0 bloom34 over 4 years ago

Same kind of issue but I am using the pause when stopped setting once the unit pauses it will start and pause a couple of times before it stays paused.

0 pat.uk over 4 years ago

Mine also starts traveling around the house while sat on the table too. I just put it on standby now to stop it going anywhere.

0 Microkid over 4 years ago

No problem here. It only starts when I press the button.

0 mcinner1 over 4 years ago

When you turn on your Edge, just have a look at the speed display! You will find out that during finding a good and stable sat-fix, the GPS jumps around your place producing speed more than 10 km/h. You can see that jumps on your screenshot. That‘s the reason for triggering the start.
Yes, with „old“ Edge 1030 this did not happen.
For the moment you just can change startroutine from autostart to promt at 10 km/h.

0 WFransL over 4 years ago

Same here. I increased the 'auto-start' to 10km/h.

0 ArelisDiaz1 over 3 years ago

I have this problem too and it turns on - when I have had turn the power completely off. it is very annoying and frustrating! I have the Garmin Fenix 6 watch with gps and I don't have this problem.

0 randybb over 3 years ago

The solution is simple - speed sensor