This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cadence sensor doesn't work on Edge 800

Former Member over 10 years ago

4 month ago I've bought edge 800 with GSC 10 speed/cadence sensor and started using it about 1 month ago. Initially everything worked fine. But then it started to show strange cadence values (it looked like it skiped some rotations). And then it stopped to show cadence data at all.
I would think it's a battery. But I started using it only month ago, and speed sensor is working fine.
Did anyone experince the same problem? Any suggestions?

0 schinder over 10 years ago

Check the magnet alignment. Put the GSC-10 into debug mode and see if the little light flashes when the magnet goes by the sensor. The sensors do fail sometimes. I had a GSC-10 replaced under warranty when my speed sensor failed.