This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Speed Sensor 2 v4.10 firmware

dugeem.david over 3 years ago

New Speed Sensor 2 firmware v4.10 has appeared in Garmin Express for my Edge 830.

Changes:

* Fixed speed spike
* Added a default wheel size

Will attempt installation over the weekend.

0 Tim8444 over 3 years ago

Installed it after the third attempt and after edge telling me, that it has got 100% and the update was successful the sensor did not connect anymore. I will now try to leave it till deep sleep and then wake it up and try again.

0 Dan A. over 3 years ago

Made the update installation.
Did not seem to have any spike issue with the v4.00.
Sensor connected with any problems at my Edge, watch and phone.

0 AN7 over 3 years ago

I installed it a bit earlier via Edge 830, no issues found during the installation, but also never had any issues before with spikes etc.

0 KevinJames over 3 years ago in reply to Dan A.

On 4.00 I noticed these speed spikes from a Velodrome session. Will see if they are fixed on 4.1

0 R32Hoo over 3 years ago

Took three tries linking to Edge 1030. Went to 25 and got stuck, went to 52 and got stuck, then finally installed. But I had to wait 30 minutes for the Edge 1030 to re connect. All good.

0 Gery over 2 years ago in reply to R32Hoo

Came home, saw the update did the update without a problem, went inside wanted to do the update for the second bike, tried 5 times, always connection lost, i went outside again and it did the update in 1go without a problem, maybe the edge needs good gps signal before it can do the update.

0 hotdogpartysausage over 2 years ago in reply to Gery

Was the Edge disconnected from you phone/WiFi when you went outside?

When I was indoors it wouldn't update until I disabled both connections then the update worked 1st time at the next attempt

0 Gery over 2 years ago in reply to hotdogpartysausage

Indoor and outdoor the edge and the phone were connected and visible, indoor it disconnected from the phone by itself and then it failed the upgrade.

0 hotdogpartysausage over 2 years ago in reply to Gery

Maybe it was because I disabled connection rather let it disconnect so it wasn't searching for the phone that allowed it to work for me

0 GT1977 over 2 years ago

Mine wouldn’t update from my Edge 830 but did update when it was paired to my iPhone and Garmin connect. However now when I ride it constantly connects and disconnects from my Edge 830 which is really annoying. Anyone else have this problem?