This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Marq Commander Stuck 24 hour time

Got a new Marq Commander. Set everything up & a few hours later for no known reason the display shifted to 24 hour time. It won’t change back. I’ve checked the settings on the watch & in Garmin Connect. They’re both set to 12 hour but the watch will not display 12 hour time. I did a reset & still same thing. Anyone else see this?

Top Replies

Dr Phil over 4 years ago in reply to BIGAAPL +1

Is it a default watch face? If it is not, try switching back to a default one.

Is it when you are in Battery Saver Mode?

Failing that try hard reset:

Synch to phone

Press and hold top left until power…

All Replies

0 Dr Phil over 4 years ago

Check on Garmin Connect on the Interweb, then Garmin Connect Mobile, then on the watch.

0 BIGAAPL over 4 years ago in reply to Dr Phil

Just looked, all three are set to 12 hour clock am/pm. Device still locked into a 24 hour clock

0 Dr Phil over 4 years ago in reply to BIGAAPL

Is it a default watch face? If it is not, try switching back to a default one.

Is it when you are in Battery Saver Mode?

Failing that try hard reset:

Synch to phone

Press and hold top left until power down. Restart.

If still not working contact Garmin Support