Instinct - 6.54 Beta Release

Hello Instinct users,

We have new beta software ready for your upcoming adventures! This is a public release candidate.

Please read the 'notes' and 'installation instructions' in the 'Updates and Downloads' page found in the link below. We look forward to your feedback!

Instinct: https://www8.garmin.com/support/download_details.jsp?id=14527

Note: Please allow for the updates to propagate across all servers. There is no need to post that the link does not work. It will after a bit of patience.

6.54 Change Log Notes:

Fixed issue where Strength activities were not displayed correctly in the Last Sport widget.

Top Replies

Garmin_ODQA over 5 years ago in reply to pprimoz +1

We found the bug and will be fixed in the next public release that will be out very soon!

All Replies

0 6619804 over 5 years ago

I still see 2 problems/bugs, which appeared in beta version 6.51 .

1)
I usually have to switch the watch off twice, because when I switch it by usual way
(Hold CTRL - Power Off), the watch immediately switches on again.
Test sequence is for instance
GPS-> Navigate-Courses-COURSE1 and back by use SET to the home screen, and then I try to switch the watch off.

2)
When the watch doesn't move, seconds digits on the main screen disappear in 14-30 seconds.
In previous versions it was 5 minutes. I do not like this shortened version.

0 pprimoz over 5 years ago in reply to 6619804

In v6.54b Power Off doesn't work too! Not even in the way you described it!

But I managed to turn off the device by shutting it down the normal way (CTRL -> GPS), but immediately after pressing the GPS I pressed and held the CTRL key for a few more seconds.

From then on, I can shut down Instinct the normal way.

0 Former Member over 5 years ago

Thanks for the update. Only thing I see so far is that the floor count is incorrect. Watch says I walked 10 (8 up and 2 down) flights of stairs. I took the elevator today so should be zero.

0 Garmin_ODQA over 5 years ago in reply to Former Member

Does your device have 1.20 Sensor Hub installed?

Menu > Settings > About > Down button 5 times > BLE/ANT/SNS

0 Former Member over 5 years ago in reply to Garmin_ODQA

I did thanks. I found the 1.20 version in the About section.

0 Garmin_ODQA over 5 years ago in reply to Former Member

So, just to confirm, you had 1.20 installed while see the incorrect Floor counts?

0 Garmin_ODQA over 5 years ago in reply to 6619804

6619804 said:
I usually have to switch the watch off twice, because when I switch it by usual way
(Hold CTRL - Power Off), the watch immediately switches on again.
Test sequence is for instance
GPS-> Navigate-Courses-COURSE1 and back by use SET to the home screen, and then I try to switch the watch off.

Thanks for reporting! We found the bug and will be fixed in the next public release that will be out very soon!

0 Garmin_ODQA over 5 years ago in reply to pprimoz

We found the bug and will be fixed in the next public release that will be out very soon!

0 Former Member over 5 years ago in reply to Garmin_ODQA

Correct.

0 Former Member over 5 years ago in reply to Garmin_ODQA

Perfect, thank you!