Feniks 3 firmware rollback

Good morning

My old Feniks 3 has just been replenished with new battery after the first did not last longer than a day or two. Unfortunately, the new battery exibits the exact behaviour. I have uninstalled everything that could cause drain, switched off wifi and bluetooth connections, and deactivated my Strava account. Still the same.

Today I tried rolling back the firmware to pre-V9 but cannot get it to work. Each time it restarts, the version is upgraded to 9.6.

Any suggestions?

Jaco

0 mcbit 9 months ago

Nothing to add other than the fact that my Fenix 3 running FW 9.6 still gets at least a couple of weeks with no activities on the original battery.

0 Data 9 months ago

My Fenix 3 is also still going strong on FW 9.6, I don't think going back to an older FW will fix this.

If a hard reset didn't work, maybe the new battery was not really new (happened to me a few times). Did the battery arrive more than half full or totally flat? If it was flat, try another one from a different source.

Otherwise, give it a week or two with normal use and charge cycles. There is power management logic in the watch that should adapt to the characteristics of the new battery.

0 trux 9 months ago

3069308 said:
Any suggestions?

Possibly the battery gauge just needs to be calibrated. Do a soft-reset, and then fully charge the watch (keep it on the charger ~1hr more, after the indicator shows 100%), then use the watch till it shuts down. Repeat the cycle twice.

Some more details and, and some additional tips are available here: Troubleshooting guide for high battery drain

0 3069308 9 months ago in reply to trux

Thanks trux, very useful indeed. And thanks for the link to the guide. In all my searching I never came across this page.