Fenix 5x hangs during sensor hub update

Fenix 5X hangs during sensor hub update.

Woke up this morning and had this text on the screen "Installerar uppdateringar för sensorhubb" translates to "Installs sensor hub updates".

No reaction when I connect the watch to the computer with the USB charging cable, the watch is NOT detected by Windows.

After re-booting it started up and connected to Windows and Garmin Express and the SW version is 25.00

Top Replies

Garmin - Chris over 3 years ago +2 verified

I am sorry there is an issue.

It has been reported restarting your watch should cause the software update to successfully complete. If your watch is hard frozen, perform a hard reset holding down your…

All Replies

+1 Garmin - Chris over 3 years ago

I am sorry there is an issue.

It has been reported restarting your watch should cause the software update to successfully complete. If your watch is hard frozen, perform a hard reset holding down your top left button until your watch shuts off.

0 micklush over 2 years ago in reply to Garmin - Chris

Chris I have also problem with my Fenix 5x, which is software 20.10 and is not possible to update it.

0 Garmin - Chris over 2 years ago in reply to micklush

When you use Garmin Express on your computer, does it push the v25.00 software update?

0 micklush over 2 years ago in reply to Garmin - Chris

No, just some TOPO and few other Maps. Software is 20.10 and is showing: “up to date”

0 Garmin - Chris over 2 years ago in reply to micklush

I just sent you a Private Message to work with you further.